Simulation Forums

Find Simulation answers, share expertise, and connect with your peers

Simulation Mechanical and Multiphysics


Warning: found trivial solution ERROR

40 Views, 2 Replies
06/09/2017 8:43 AM

Hi All,

 

I have encountered following issue, the error reported in results log is depicted on figure below.

Analysis: static linear, 3D bricks model created in Inventor 2018, exported to AutoCad DWG 2013 and merged into Autodesk Simulation Mechanical 2017. Supports and loads applied, as well as materials. After finished calculation displacements and stresses are zero. Meshed successfully.

 

Please help?

 

Capture.PNq1.PNG

 


Report Inappropriate Content
Message 1 of 2 ( Views: 40 )

Re: Warning: found trivial solution ERROR

06/09/2017 7:20 PM

Hi @EngineerMickeyMouse

 

Based on some notes that I found, I suggest changing the solver to Sparse: "Setup > Model Setup > Parameters > Solution > Type of solver > Sparse".



John Holtz, P.E.
Technical Support Specialist
Customer Service & Support
Autodesk, Inc.


Report Inappropriate Content
Message 2 of 2 ( Views: 34 )