Simulation Forums

Find Simulation answers, share expertise, and connect with your peers

Simulation Moldflow Adviser


Moldflow Adviser 2010, how to setup the add-in option in Solidworks 2011

830 Views, 2 Replies
04/12/2011 4:40 PM

How do I add Moldflow to the "add-ins" in Solidworks 2011? I went to tools, add-ins..., and there is no selection to start the Moldflow add-in. I have Win7x64 with Moldflow Adviser 2010x64 loaded.

Thanks.

 

K.B.


Report Inappropriate Content
Message 1 of 2 ( Views: 830 )

Re: Moldflow Adviser 2010, how to setup the add-in option in Solidworks 2011

04/21/2011 3:39 PM

Found out when 2010 Advisor SP1 is installed it loads the Add-in option in Solidworks 2011.

If you updated to 2010 Advisor R2 SP1 it will not install the add-in and will remove the Add-in from the prior version.

So you must use the STL import option, just a few more steps.


Report Inappropriate Content
Message 2 of 2 ( Views: 783 )