Simulation Forums

Find Simulation answers, share expertise, and connect with your peers

Simulation CFD


Injector Hat Airflow Simulation

58 Views, 4 Replies
03/12/2018 2:47 AM

Hello my name is Christopher Hidalgo, and for the past 2 years I have been designing an injector hat for a roots supercharger. This device bolts on top of the supercharger opening, and feeds the blower with clean air. I have been trying to complete an airflow test to see if there is any turbulence from within the housing. This injector will be running on top of a blown, pro modified drag car at over 230mph. However, I am having issues with the mesh and inputting correct numbers in order to receive accurate results. It would be great if someone may help through a video chat, or by calling my number at 831-210-0761. My most used and preferred email is christopherahidalgo@student.hartnell.edu. Thank you very much.

done v1.jpgIt is a carbon fiber injector standing 9.75 inches tall with a 74 square inch inlet opening--leading to an outlet opening of 4.5 x 10.5 inches.done v2.jpg


Report Inappropriate Content
Message 1 of 4 ( Views: 58 )

Re: Injector Hat Airflow Simulation

03/12/2018 12:38 PM

Hi Christopher,

 

Please can you upload a .cfz file (found under save as). I can then take a look at your setup and hopefully offer some suggestions.

 

Al the best,

David


David Short
Technical Support Specialist, Simulation

Report Inappropriate Content
Message 2 of 4 ( Views: 43 )

Re: Injector Hat Airflow Simulation

03/14/2018 4:44 PM

Thank you sir. C:/Users/Chris/Downloads/cfd injector study/cfd injector study.cfz


Report Inappropriate Content
Message 3 of 4 ( Views: 33 )

Re: Injector Hat Airflow Simulation

03/15/2018 8:45 AM

Hi Christopher,

 

Can you upload the file as an attachment please.

 

All the best,

David


David Short
Technical Support Specialist, Simulation

Report Inappropriate Content
Message 4 of 4 ( Views: 27 )